Wall mount for EGO 56V Chainsaw

After much development, I can finally offer a mount for the hefty EGO 56V Chainsaw that will securely hold this heavy tool vertically on a wall.  The mount is designed to fit into the battery rails of the tool, letting the tool click into place.  Pull the battery release on the tool to release from the mount.   I tested this with my 14 inch EGO Chainsaw.

Note: Chain oil may drip, so you may want to keep the sheath on to catch oil, or place something under the chainsaw.

These chainsaw mounts are 3D printed (FDM) using durable and non-toxic PET-G. PET is the same plastic used to make water bottles, and Glycol is added for the 3D printing process.

Remember to leave enough room to the left of the mount to slide the chainsaw into the rails.  I recommend securing the rack with at least two screws into a wall stud or other wood backing to handle the stress of repeated loading/unloading the chainsaw.

Disclaimers:
Hand tighten screws to avoid damaging the mount or wall. Incorrect installation of mount may cause damage to wall and/or tool. Not responsible for damage caused by improper installation.  Tool not included.

Recommended temperature range: 15F-125F or -10C-52C

Frequently Asked Questions

What size screw should I use?
I used 2x 3 inch countersunk deck screws into the wall stud and 2x #6-32x1-3/4in hollow wall anchors for the other two screw holes for these photos.  You can use pan head or countersunk screws.  Remember to only hand tighten.  Screws may squeak while driving through the mount.

Can I turn this mount upside down?
Inverting the mount is not recommended as that would point the cutting chain dangerously in the air and add a lot of stress to the mount that could cause it to pull out of the wall and fall with the tool.

When will you have more of the color I want?
I regularly print more parts. Message me with the quantity you are looking for and I can usually print them within a week, assuming I have the materials in stock. I will let you know if there will be delays.

Can you make this in a custom color?
Yes. If I have the color in stock I can usually make the racks within a week, depending on my backlog of orders. Special order colors may require a minimum quantity in order to stock the color, and it can take 1-2 weeks to get a new color.